VEEMUX SM-nXm-C5AVR-LCD

• Female 15-pin HD input connectors.
• Female RJ45 output connectors.
• Bandwidth: 175 MHz, fully loaded.
• 10/100BaseT Ethernet interface.
• Supported protocols: HTTP, HTTPS, Telnet
• RS232 interface.

Dimensions

• WxDxH (mm): 483x304.8x88.9

Power

• 110 or 220 VAC at 50 or 60 Hz via IEC connector.

Cables

• Interface cables between your computers and the switch are required for proper operation.
  • Use VEXT-xx-MM to connect VGA video from the computers to the switch.
  • Use HDAVEXT-xx-MM to connect VGA video and stereo audio from the computers to the switch.
• Use CAT5, CAT5e or CAT6 solid straight through cable for TIA/EIA-568B wiring terminated with standard RJ45 connectors.
• Cables not included

Environmental

• Operating temperature: 0°C to 38°C (32°F to 100°F).
• Storage temperature: -30°C to 60°C (-20°F to 140°F).
• Operating and Storage Relative Humidity: 17 to 90% non-condensing RH.

Regulatory Approvals

• CE, RoHS

Warranty

• Two years

Remote Unit (Receiver)

Video Output

• Female 15-pin HD connector.
• Supports resolutions up to 1920x1440; refer to the resolution chart below for resolutions at different lengths.
• Output impedance: 75 Ohms.
• Maximum output level for video: 1.45Vp-p.
• Video quality adjustment for different lengths of CAT5/5e/6 cable is done manually for video-only units and automatically for audio/video units.

Optional Audio

• 3.5mm stereo audio jack.
• Frequency response: 20 Hz to 20 kHz, ±.5dB.
• Signal-to-Noise Ratio (SNR): >72 dBA.
• Total Harmonic Distortion and Noise (THD+N): <0.06%.
• Stereo crosstalk: -70 dB.
• Maximum output levels: 3.1Vp-p (line level).
• Line level output; supports multimedia speakers.
  • CD quality audio output.

Dimensions

• WxDxH (in): 88.9x78.7x30.5

Power

• 110 or 220 VAC at 50 or 60 Hz via AC adapter.

Environmental

• Operating temperature: 0°C to 38°C (32°F to 100°F).
• Storage temperature: -30°C to 60°C (-20°F to 140°F).
• Operating and Storage Relative Humidity: 17 to 90% non-condensing RH.

Regulatory Approvals

• CE, RoHS

Warranty

• Two years

Front Panel Interface

• Liquid Crystal Display (LCD) can display all current connections.
• Locally change input and output selections with front panel buttons.
• Digital VU-Meter displays audio levels for the currently selected port.
• Configuration and control can be done using the front panel buttons.
• Main menu allows the user to:
  • Set serial address.
  • Set serial speed.
  • Set IP address.
  • Set Subnet Mask.
  • Adjust contrast.
  • Force compensation.
  • Show size.

RS232 Control

• Configuration and control can be done through the serial port.
• Control the switch using the NTI Switch Control Program with Graphical User Interface (GUI control) via RS232.
• Selectable baud rate: 1200 through 9600.
  • Baud rate is set via the main menu, serial command, telnet or
    web page.

Commands

• CS-causes one INx/OUTx connection to occur.
• CA-causes all inputs to connect to specified output.
• RO-reads what input is connected to specified output.
• CC-save matrix.
• RC-recall matrix.
• CB-change baud rate.
• RV-version information.
• RU-reads size of matrix, reports number of inputs and number of outputs on specified switch.
• EA-set the IP address.
• EM-set the IP mask.
• EG-set the default gateway.
• ET-set the webserver timeout.

Ethernet Control

• Configuration can be done over the Internet via web page or telnet.

Web Server (view product demo)

• Security is ensured by password and user configurable timeout.
• Up to 25 users can access the web page at one time.
• The user can access the following pages:
  • Switch page: allows the user to connect any input to any output, save and recall up to ten connections.
  • Administration pages: administrator can access setup pages, port setting page and update firmware page. Assign names to video and audio inputs and outputs.
  • Password page: allows the user to change the password for accessing the web interface.
  • Help page: documentation on the usage of the web interface.
  • Update Web Server page: globally update the web server to any settings that have been changed.
  • Logout page: view currently active connections and logout of the web interface.

Telnet

• Security is ensured by password.
• Commands are similar to RS232 commands.
• The telnet server listens on ports 2000 and 2005.
  • Port 2000 is for an operator telnet session.
  • Port 2005 is intended for a software control type session.